Cherry Hollow End E-Z Buck® should be installed with
automatic riveting machines or by a squeezer of sufficient
size to provide the upset loads listed below.
The Installation Snap Dies are designed to center the squeezer on
the rivet and prevent damage to the structure. Be sure the die center
pin is in the rivet center dimple before actuating the squeezer.
Loads required to provide an acceptable upset are shown below.
Loads deviating from these values should be questioned, but are
acceptable if all inspection requirements shown below are met.
- 839C10-4 / 839C10-5 / 839C10-6 / 839B13
- 202204ADLMRO
- N/A
- NA
- https://www.cherryaerospace.com/docs/catalogs/CA-1028.pdf
- Sheet Metal Tool Room
