Used when the fuel tank access is removed. The table has holes to place the fuel access on the table, avoiding the damage of these. Note: Racks are available in the interior of Hangar 1…
Cradle – APU Removal and Installation
Used to install and remove the Auxiliary Power Unit P/N: WE3800770-3.
Set-Backlash Measurement
The AGE-04267-401ADLMRO "GSE 258-Set, Backlash Measurement" tool is used to perform operational backlash tests on ailerons and elevators of ERJ-180/190 aircraft.
A54001-196ADLMRO
The tool is used to unload force apply to PW2000 engine, during diagonal brace removal and installation. The Diagonal brace removal or installation is done with out removing the engine from the wing.The tool is…
TRANSMITTER HOSE – PITOT PRESSURE TEST BOX TO…
Used on B717 aircrafts to connect the Air Data Model Test Set (COM-1914) to the rudder limiter pitot tube. This connection allows to perform the Rudder Limiter Pitot Line Leak Test.
Spanner Die, Grease Fitting Lid
Used for removal and installation of grease fitting lid on CRJ aircraft empennage.
MLG Metering – Pin Retaining Nut
MLG Metering – Pin Retaining Nut tool is used on CRJ 700/900/1000 aircraft to remove the piston/axle assembly with the lower bearing, the outstop tube, and the upper bearing from the shock strut outer cylinder…
Shoring support for pylon
Use the tripod jack in conjunction with a load cell to perform the maintenance task on the strut (pylon) to be repaired in accordance with AMM 54-51-00. Maximum load capacity 3000 Lb
Tool Tension
Used to set zero on the quadrant of the aileron tension regulator