Used when the fuel tank access is removed. The table has holes to place the fuel access on the table, avoiding the damage of these. Note: Racks are available in the interior of Hangar 1…
VERNIER ANALOGO 0″ A 6″
Vernier for measurement for small elements from 0 to 6″.
TORQUE DE CARATULA 3/8″
Dial torque wrench 0 – 150 lb/in. To apply a certain torque to certain parts, such as screws, nuts, etc.
VACUUM GENERATOR
This unit features a vacuum gauge for precise readings and a brass regulator for exact control. Vacuum can be measured Inches Hg or Millibars. Positive Air Pressure of 80-100 PSI is needed to operate this…
GSE 258 SET – BACKLASH MEASUREMENT, ELEV
Used to put the protractor on the elevator and on the aileron for backlash measurement.
GSE 175 DEVICE – BACKLASH MEASUREMENT
Used to apply forces necessary to measure the backlash of the flight control surfaces (aileron, elevator and rudder). This GSE consists of a dynamometer adapter with a rubber cushioned fork designed to attach to the…
GSE 026 SET – JACKING ADAPTER
Used to insert at the jacking points of the aircraft wings and rear fuselage to assist in jacking the aircraft. This GSE is a steel-made machined part with an inserting pin that fits in the…