Used when the fuel tank access is removed. The table has holes to place the fuel access on the table, avoiding the damage of these. Note: Racks are available in the interior of Hangar 1…
GRAY WATER SYSTEM TESTER
This tool is used to perform the vacuum and check test of the gray water lines.
PASSENGER AND SERVICE DOOR SAFETY PIN
Internal manufacturing pin, used to prevent an inadvertent activation of the trigger in the pneumatic assembly of the passenger and service door emergency opening system.
DOLLY WHEEL/BRAKE CHANGER
Internal manufacturing Dolly, for maintenance activities where is needed the removal / installation of landing gear wheels, as well as carry them.NOTE: Component subject to the MARSHALL program of GSE.
SHIMMY DAMPER TOOL
Internal manufacturing tool to used to block the axial movement of the shimmy damper of the landing gear.
ANGLE MODIFIED WRENCH 7/16 & 9/16
Internal manufacturing tool for use in removal tasks / installation of Fodward Cargo-Door-Frame fittings according to AMM 53-21-29 of EMB 170 aircraft.
MANUAL DOLLY FOR TIRES
Internal manufacturing tool for use in landing gear wheel removal tasks. NOTE: Component subject to the MARSHALL program of GSE.
DIES TO TIGHTEN CLAMPS
Internal manufacturing tool for use in tasks of removal and installation of several ducts (with specific torque and butterfly clamps).