Used when the fuel tank access is removed. The table has holes to place the fuel access on the table, avoiding the damage of these. Note: Racks are available in the interior of Hangar 1…
IMPACT SOCKET DREIVE 1″ 6 POINT 1-5/16″
“Snao-On” Impact Socket 1″ drive, 6 pts, 1-5/16" used to install / removal screws and nuts in maintenance tasks.
TORQUE ADAPTOR#24 3/4″
“Snap-On” Torque adapter spline #24 3/4″ drive 1/2″ used to help to install / remove screws and nuts in maintenance tasks.
DYNAMOMETER 10000LB
Tool used to measurement forces up to 10,000 Lbf in maintenance tasks.
LITTLE BRUTE TOOLING.
Air-actuated, hydraulic puller is used to expanding holes up to 1/2-inch diameter in aluminum and mild steel and up to 3/8-inch diameter in titanium and high-strength steel.
WATTMETER
Tool used to measure RF power and load coupling on 50 ohm coaxial transmission lines. The meter provides direct readings in Watts with extended scale to facilitate reading and is graduated in 25, 50 and…
SURFACE GRINDING COMPARAT
Tool used to compare surfaces finish to one of the swatches on these scales. The finishes are expressed in microinches (µ”).