Used when the fuel tank access is removed. The table has holes to place the fuel access on the table, avoiding the damage of these. Note: Racks are available in the interior of Hangar 1…
STAB.TRIM CUTOUT TESTER
Used to test stabilizer trim cutout system.
GAUGE SET, HYDRAULIC BRAKE SYSTEM
Used to check brake pressure after any maintenance to the braking system where the brake line is opened or any component in the braking system is replaced.
FORCE GAGE EQUIPMENT
Used to measure the landing gear lever forces. The three forces are the pullout force, and tangential forces; up and down.
WINGLETS SLING
Used for installation and removal of winglet, Section 19.
TORQUE WRENCH 0-250 LB/FT
Dial torque wrench 0 – 250 lb/ft. To apply a certain torque to certain parts, such as screws, nuts, etc.
RIGGING SIMULATOR – ESCAPE SLIDE, PASSEN
Used to perform proper Passenger Door rigging simulation.
AXLE NUT SOCKET EQUIPMENT
Used to install or remove the MLG or NLG retention nut.
PROTECTOR THREAD
Used to prevent damage to the APU mounting (cone) bolt threads during APU removal/installation.