Used when the fuel tank access is removed. The table has holes to place the fuel access on the table, avoiding the damage of these. Note: Racks are available in the interior of Hangar 1…
STRAP WRENCH
Used to remove/install electrical connectors at engine/strut interface. For electrical connectors gripping diameter 0.50" to 2.50", max torque value 164 In-Lbs.
CHECK VALVE DEACTIVATOR
Used to hold open check valve (M913-1 or 4663-8) during heat exchanger and plenum/diffuser assembly cleaning using C21003. Tool allows airplane to provide pneumatic air to run C21003 (as opposed to using a ground air…
ADAPTER JACK FOWARD BODY
Used to adapt forward jacking point to standard tripod jack with 3/4" radius cup.
SPRING EXTENDER
This tool is used to remove/installl the downlock springs on the nose and main landing gear.
Head Set
Head set for communication between aircraft and cockpit. It includes noise shielded microphone
TESTER LOOP RESIST KIT
Used to make "non-intrusive" wire bundle and coax cable shield resistance measurements by inductively injecting a low voltage into the shield and measuring the current flowing through the shield loop. The Accessory Kit (p/n 906-10271-3)…