Used when the fuel tank access is removed. The table has holes to place the fuel access on the table, avoiding the damage of these. Note: Racks are available in the interior of Hangar 1…
TORQUE ADAPTER FOR SLAT CYLINDER JAM NUT
Internal manufacturing tool to use to install and remove slat drive mechanism cylinder actuating jam nut.
TORQUE ADAPTER FOR SLAT CYLINDER JAM NUT
Internal manufacturing tool for use in removal and installation of the jam nut of the actuator cylinder of the slats guide mechanism.
MLG SHOCK OLEO STRUT SERVICE LINE FOR MD88
Internal manufacturing tool for use in landing gear leg service tasks.
PILOT´S DOOR RIGGING TOOL
Internal manufacturing tool for pilot cabin door adjustment tasks.
VERTICAL STABILIZER LEADING EDGE SLING
Internal manufacturing tool to use to vertical stabilizer maintanance for MD88 / MD90 / B717 AC.
CABLE BLOCK FOR CABLE RIGGING
Internal manufacturing tool for use in control surface adjustment tasks. NOTE: This tool can be used as an alternative to "Control Cable Clamp Assembly" Part.No. A20005-10
MANUAL DOLLY FOR TIRES
Internal manufacturing tool for use in landing gear wheel removal tasks. NOTE: Component subject to the MARSHALL program of GSE.
RIGGING PIN SET B717
Internal manufacturing tool for use in tasks of adjustment of flight control surfaces.