Used when the fuel tank access is removed. The table has holes to place the fuel access on the table, avoiding the damage of these. Note: Racks are available in the interior of Hangar 1…
EXTENSION 1″X13-1/8 SNAP-ON
1" Drive 13-1/8" Pin Hole Impact Extension.
GSE 124 NLG INSTALLATION SET
Tool used to remove / install the NLG.
TORQUIMETRO 0-1500 FT/LB
Dial torque wrench 0 – 75 lb/in. To apply a certain torque to certain parts, such as screws, nuts, etc.
PROTRACTOR-CONTROL SURFACE
Tool used to measure the rudder deflections.
FLOWMETER – HYDRAULIC PDQ
Used to accurately measure external pump output during the hydraulic system internal leakage check.
CABLE TIE TOOL GUN
Tool used to tighten cable ties and trim the excess in one motion. For 0.18"-0.53" Wide Ties with 50-250 lb. Break Strength